![]() I attached a screen shot of the utility showing the settings. I\'ve set Encoder 1 to \"Use: Feedback (1)\" and then Encoder 2 to \"Use: Feedback (2)\"Īll digital inputs (except DIn 4, which is used for E-Stop) are set to no action. Neither motor works in closed loop, but both work in open loop. Neither Feedback 1 or 2 register anything (in open loop or closed loop). The RoboteQ AX2550 controller is used to control the DC motors, which allows the precise. While both lights blink on the Motor Control Utility, indicating a good connection between the encoders and the motor controller, only Counter 1 works-Counter 2 stays at -1. This embedded device not only performs image processing. Speed 1 RPM registers a sensible value as I vary the open loop speed The lights on the RoboteQ Motor Control utility blink on the encoder inputs as the motor spins around. I can verify this much that the encoders are working: But whenever I set the mode to closed speed, the motors are not responding. ![]() However, it doesn\'t work if I put them in closed loop speed control. Hello, I have SDC2130 When I set the mode to open loop, the motors are running. I can control my motors in open loop speed mode just fine. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |